GENERAL INFORMATION
91
Data Recording Mode
The data recording mode and the data
retrieval mode will only operate when
the lap timer (lap) is turned on.
1. Lap display
2. Stopwatch icon
3. Lap time
To select the data recording mode:
▼ Turn the ignition to the ON position.
▼ Press and release button A until Lap
is shown in the display screen then
press button B.
▼ L01 and a stopwatch icon will be
shown in the speedometer display,
and the lap timer will be shown in
the display screen.
▼ Pressing the starter button (with the
engine running only) will start the lap
timer. The display will show the lap
time in minutes, seconds and
hundredths of a second, and the
stopwatch icon is on.
New Lap Recording
1. Starter button
At the end of the lap, pressing the
starter button again will register the
start of a new lap. The display will show
the last lap time for five seconds then
the new lap number for five seconds.
After this time, the speedometer display
will show the current lap number and
the display screen will show the current
lap time.
To Next Page
Loading...
Need help?
General
