GENERAL INFORMATION
99
With the Engine Off
▼ The ignition is switched ON.
▼ The engine stop switch is in the RUN
position.
With the Engine Running
▼ Neutral gear is selected or the clutch
is pulled in.
1. Selected riding mode
▼ Once the ABS, MAP and TTC settings
have changed, the selected riding
mode will be shown and the previous
mode will no longer be shown.
Selecting a Riding Mode –
Motorcycle Moving
Warning
The selection of riding modes while
the motorcycle is in motion requires
the rider to allow the motorcycle to
coast (motorcycle moving, engine
running, throttle closed and no brakes
applied) for a brief period of time.
Riding mode selection while the
motorcycle is in motion should only be
attempted:
- At low speed
- In traffic free areas
- On straight and level roads or
surfaces
- In good road and weather conditions
- Where it is safe to allow the
motorcycle to briefly coast.
Riding mode selection while the
motorcycle is in motion MUST NOT be
attempted:
- At high speeds
- While riding in traffic
- During cornering or on winding
roads or surfaces
- On steeply inclined roads or surfaces
- In poor road/weather conditions
- Where it is unsafe to allow the
motorcycle to coast.
Failure to observe this important
warning will lead to loss of motorcycle
control and an accident.
To Next Page
Loading...
Need help?
General
