MAINTENANCE
126
Rear Suspension Spring Preload
Adjustment
Trident Only
The spring preload adjuster is located at
the bottom of the rear suspension unit.
Rear adjuster settings are counted from
one, with position one being with the
adjuster turned fully clockwise. Position
one gives the minimum amount of
spring preload. There are seven adjuster
positions in total. Position seven gives
the maximum amount of spring preload.
1. Spring preload adjuster ring
A. Counterclockwise direction
B. Clockwise direction
To change the rear suspension spring
preload setting:
▼ Locate the C spanner supplied in the
tool kit.
▼ Insert the C spanner into the slots of
the spring preload adjuster ring.
▼ Turn the spring preload adjuster ring
counterclockwise (shown as direction
A in the diagram) towards the left
hand side of the motorcycle to
increase spring preload.
▼ Turn the spring preload adjuster ring
clockwise (shown as direction B in
the diagram) towards the right hand
side of the motorcycle to decrease
spring preload.
To Next Page
Loading...
Need help?
General
