GENERAL INFORMATION
46
▼ The selected riding mode is activated
once the following conditions for
switching riding modes have been
met:
Motorcycle Stationary - Engine Off
▼ The ignition is switched ON.
▼ The engine stop switch is in the RUN
position.
Motorcycle Stationary - Engine Running
▼ Neutral gear is selected or the clutch
is pulled in.
Motorcycle in Motion
Within 60 seconds of selecting a riding
mode the rider must carry out the
following simultaneously:
▼ Close the throttle.
▼ Make sure that the brakes are not
engaged (allow the motorcycle to
coast).
The riding mode selection is now
complete and normal riding can be
resumed.
Fuel Consumption
The Fuel Consumption display shows
fuel consumption information.
FUEL CONSUMPTION
mpg
35.5
186
069
miles
1
2
3
mpg
1. Instantaneous fuel consumption
2. Range to empty
3. Average fuel consumption
Instantaneous Fuel Consumption
An indication of the fuel consumption at
an instant in time. If the motorcycle is
stationary, '-.--' will be shown.
Range to Empty
This is an indication of the predicted
distance that can be traveled on the
remaining fuel in the tank.
Average Fuel Consumption
This is an indication of the average fuel
consumption. After being reset, '0.0' will
be shown until 0.1 miles/km has been
covered.
Note
After refueling, the fuel gage and range
to empty information will be updated
only while riding the motorcycle.
Depending on the riding style, updating
could take up to five minutes.
To Next Page
Need help?
General
