MAINTENANCE
127
Rear Suspension Spring Preload
Adjustment
Tiger Sport Only
The spring preload adjuster is located
near to the rear suspension unit and is
accessible from the left hand side of the
motorcycle.
1. Spring Preload Adjuster
To change the rear suspension spring
preload setting:
▼ Turn the spring preload adjuster
clockwise towards the right hand
side of the motorcycle to increase
spring preload.
▼ Turn the spring preload adjuster
counterclockwise towards the left
hand side of the motorcycle to
decrease spring preload.
Bank Angle Indicators
Warning
Always replace the bank angle
indicators before they are worn to
their maximum limit.
Use of a motorcycle with bank angle
indicators worn beyond the maximum
limit will allow the motorcycle to be
banked to an unsafe angle.
Banking to an unsafe angle may cause
instability, loss of motorcycle control
and an accident.
Bank angle indicators are located on the
rider's footrests.
1. Bank angle indicator
Bank angle indicators must be replaced
when they have worn down to the
maximum wear limit of 0.59in (15mm) in
length remaining. The maximum wear
limit is shown by a groove on the bank
angle indicator.
Regularly check the bank angle
indicators for wear.