GENERAL INFORMATION
40
Anti-lock Braking System (ABS)
Warning Light
When the ignition switch is
turned to the ON position, it is normal
that the ABS warning light will flash on
and off. The light will continue to flash
after engine start up until the
motorcycle first reaches a speed
exceeding 6 mph (10 km/h) when it will
go off.
Note
Traction control will not function if there
is a malfunction with the ABS. The
warning lights for the ABS, traction
control and the MIL will be illuminated.
The warning light should not illuminate
again until the engine is restarted
unless there is a fault.
If the warning light becomes illuminated
at any time while riding it indicates that
the ABS has a malfunction that requires
investigation.
Warning
If the ABS is not functioning, the brake
system will continue to function as a
non-ABS equipped brake system.
Do not continue to ride for longer than
is necessary with the warning light
illuminated.
Contact an authorized Triumph dealer
as soon as possible to have the fault
checked and rectified. In this situation
braking too hard will cause the wheels
to lock resulting in loss of motorcycle
control and an accident.
Turn Signals
When the turn signal switch is
turned to the left or right, the indicator
warning light will flash on and off at the
same speed as the turn signals.
Hazard Warning Lights
To turn the hazard warning lights on or
off, press and release the hazard
warning light switch.
The ignition must be switched ON for
the hazard warning lights to function.
The hazard warning lights will remain on
if the ignition is switched OFF, until the
hazard warning light switch is pressed
again.
High Beam Light
When the ignition is switched
ON and the headlight dimmer switch is
set to HIGH BEAM, the high beam
warning light will illuminate.
To Next Page
Loading...
Need help?
General
