2-4 Electrostatic Classifier Model 3082 and SMPS Spectrometer Model 3938
Table 2-9 lists optional accessories and replacement parts for the 3938
SMPS spectrometer.
Table 2-9
Optional Accessories and Replacement Parts
Part Number/
Model Number
Aerosol Instrument Manager
®
software and manual
Aerosol Neutralizer (Kr-85, 2 mCi)
Aerosol Neutralizer (Kr-85, 10 mCi)
Advanced Aerosol Neutralizer (soft x-ray, <9.5 keV)
Lead shielding for 3077A neutralizer
Side-support bracket for 3081A DMA
3/8 inch inlet for Nano DMA
1 roll Conductive tubing, 1/4-inch
1 roll Conductive tubing, 3/8-inch
Replacement blower for 3082 Classifier
Replacement flowmeter for 3082 Classifier
Replacement HEPA capsule filter (2 required)
Maintenance Kit for 3082 Classifier (see Table 6-1)
Unpac k i n g
Remove the Accessory Kit and manual from the shipping container before
carefully unpacking the Electrostatic Classifier. Use the packing lists to
verify that there are no missing components.
Save the original shipping container and packing materials to use for future
shipping.
If anything is missing, or appears to be damaged, contact your TSI
representative or TSI Customer Service using one of the following
methods:
Telephone: 1-800-874-2811 (within the US)
001-651-490-2811 (outside the US)
E-mail: particle@tsi.com.
See Chapter 6, Returning the Electrostatic Classifier for Service for
instructions on how to return the instrument to TSI.
Ventilat i o n Require m e nts
The classifier cabinet is designed to be cooled by room air drawn in
through a filter from the back of the cabinet and exhausted through the
side. Therefore, install the cabinet with at least a two-inch (50 mm)
clearance between the back panel and any other surface.
To Next Page
Loading...
Need help?
General
