Chapter 2
The Pump module design does not allow for installation
outdoors without any protection from the elements. Always
operate it within an enclosure.
The DustTrak external pump module does not require an A/C adapter. It is
always powered off the DustTrak monitor.
1. The power connector and the flow quick connect “click” when securely
connected. The power connector must be rotated clockwise past the
locking pin.
2. Do not hot-plug the External Pump Module when the DustTrak monitor
is turned ON. Always connect the External Pump module first and then
turn the DustTrak monitor ON.
3. TSI recommends that the DustTrak monitor with the external pump be
operated in the Model 8535 Environmental Enclosure.
4. TSI recommends that the pump module be operated when mounted on
its feet and avoid operating at other orientations as much as possible.
5. Pump module and the DustTrak monitor should be at the same
electrical potential.
6. The additional port on the external pump module is where the pump
exhausts the flow. For applications where the DustTrak monitor is
sampling from a chamber or a duct at pressures significantly different
from the ambient, TSI recommends plumbing the exhaust of the
external pump back in to the chamber/duct.
Using the AC Adapter to Run Instrument
The AC adapter allows you to power the DustTrak monitor from an AC wall
outlet. When using the AC adapter, the batteries (if installed) are bypassed.
Battery Charging
This instrument will charge the Lithium Ion battery packs. Insert the batteries
into the battery compartment, plug the instrument into AC power, and turn the
instrument on. Batteries will charge only when the instrument is on and in
stand-by mode. Batteries will not charge if the instrument is turned off or is
actively taken measurements. Charging will stop when the batteries are fully
charged.
When Charging Battery the ambient temp MUST NOT
exceed 42°C.
To Next Page
Loading...
Need help?
General
