Operation
Taking Mass Concentration Measurements
Measurements are started and controlled from the main screen.
Prior to starting a measurement the instrument should be zeroed from the
Setup screen and the run mode should be configured and selected from the
RunMode screen.
When the instrument is on, but not taking any mass measurements the start
button will be green and instruments pump will not be running. To start taking
a measurement, press the green start button.
For the Model 8530EP DustTrak monitor with external pump, make sure the
external pump is connected to the DustTrak monitor as described in
Chapter 2. If the pump is not connected and the green start button is pressed,
the DustTrak monitor will identify that the pump is not connected and a
warning will be displayed as shown below:
To Next Page
Loading...
Need help?
General
