EasyManuals Logo

UNI-T UT803 User Manual

UNI-T UT803
58 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #7 background image
5
Safety Information
This Meter complies with the standards IEC61010: in
pollution degree 2, overvoltage category (CAT. I 1000V,
CAT.II 600V) and double insulation.
CAT III: Distribution level, fixed installation, with smaller
transient overvoltages than CAT. IV
CAT IV: Primary supply level, overhead lines, cable
systems etc.
Use the Meter only as specified in this operating manual,
otherwise the protection provided by the Meter may be
impaired.
In this manual, a Warning identifies conditions and
actions that pose hazards to the user, or may damage
the Meter or the equipment under test.
A Note identifies the information that user should pay
attention on.
International electrical symbols used on the Meter and
in this Operating Manual are explained on page 8.
Model UT803: OPERATING MANUAL

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the UNI-T UT803 and is the answer not in the manual?

UNI-T UT803 Specifications

General IconGeneral
BacklightYes
Product typeDigital multimeter
Frequency range6 - 60000 kHz
AC current range0.06 - 10 A
DC voltage range0.6 - 1000 V
Capacitance range6 - 6000 nF
Statistic functionMaximum, Minimum
Resolution (frequency)100000 Hz
Resolution (AC current)6000 µA
Basic accuracy (frequency)±(0.1%+3)
Basic accuracy (DC current)±(0.5%+3)
Basic accuracy (DC voltage)±(0.3%+2)
Basic accuracy (resistance)±(0.5%+2)
Basic accuracy (capacitance)±(2%+5)
Temperature measurement range-40 - 1000 °C
Dimensions (WxDxH)310 x 240 x 105 mm
Battery voltage1.5 V
Weight and Dimensions IconWeight and Dimensions
Weight2400 g

Related product manuals