UNI-T UTD2102C User Manual

1. To user trigger level knob to alter trigger level
and instruct trigger level line by seeing trigger mark
on the screen so that it moves vertically with knob
rotation. Variation of trigger level in lower part of
screen can be observed when mov ing trigger level
at the same time
.
2. (As shown in Figure 1-12,) TRIGGER MENU ca
n
be us ed to alter trigger setup
.
User can press [F1] key to select “edge” trigger
.
n trigger signal amplitude
.
i
4
.
To press FORCE button: To produce 1 trigger
signal forcefully for mainly application for normal
and s ingle trigger mode
.
Operating Manual for UTD2000/3000
14
They can press [F2]key to select “trigger source
”
to CH1
.
They can press [F3] key to set “gradient” of edge
type to ascending
.
They can press [F4 ]key to set “trigger mode” to
automatic. They can also press F5 key to set
“trigger coupling” to AC
.
They can press [50%] button for 5.7-inch oscillograp
h
and press [SET TO ZERO] key for 7-inch oscillograph
.
It also has to set vertical middle point of trigger level
2
.

UNI-T UTD2102C Specifications

General

Brand	UNI-T
Model	UTD2102C
Category	Test Equipment
Language	English