Oper ating Man ual for UTD2000/ 3000
7
ĸIn digital storage oscilloscope to set the probe
attenuation factor. The attenuation coefficient of
vertical gear ratio change instruments, whic
makes measurement resultsSetup method of
attenuation coefficient of probe is as follows to
show amplitude of measured signals correctly
Please press
Figure 1-6 Setup of deflection coefficient of probe
on digital storage oscillograp
F4 key for menu display of 10
Connect probe and grounding clip to
corresponding connection ends then press [AUTO]
button. As shown in Figure 1-7, square wave (1kHz
about 3V and peak value) can be displayed withi
several seconds. It has to inspect CH2 by the same
method then press [OFF] function button so as to
power off CH1. It has to press [CH2] function butto
to power on CH2 and repeat the second and third
To Next Page
Loading...
Need help?
General
