UNI-T UTD2202CE User Manual

Operating Manual for UTD2000/3000
74
comparison without waveform overlapping for the
first and second channels
.
2. To measure delay of sine signal caused b
y
circuit then observe waveform variation.
ķ
ĸ
Delay of automatic measurement channel
To press MEASURE button to display automatic
measurement menu
;
To press F1 k ey to enter into measurement menu
category for selection
;
To press F4 key to enter into time measurement
parameter list
;
To press F5 k ey twice to enter into 3/3 page
;
To press F2 k ey to select delay measurement
;
To press F1 k ey to select CH1 then press F2 k ey to
select CH2 then press F5 as enter ke
y
You can see delay value from “CH1-CH2 delay” i
n
F1 area
.
Observation of waveform variation (shown i
n
following figure
)
Figure 3-2: Waveform dela
y

UNI-T UTD2202CE Specifications

General

Brand	UNI-T
Model	UTD2202CE
Category	Test Equipment
Language	English