Making calls 15
Enter a dial pause when dialling
¤ Press and hold the hash key. A P is shown on the display
Incoming calls
An incoming call is indicated by ringing, by a display on the screen and by the flashing Talk / Handsfree
key ( / ).
Accept a call:
• Press the Talk key or Accept
• If Auto Answer is activated: Remove the handset from the charging cradle
• Accept a call on the headset
Switch off ringtone: Silence . . . the call can be accepted for as long as it is shown on the display
Information about the caller
The caller's phone number is displayed.
If the caller's number is saved in the local directory, the name is displayed.
During a conversation
Handsfree mode
Activating/deactivating handsfree mode during a call and when establishing a connection:
¤ Press the handsfree key
Call volume
Muting the microphone
When the microphone is switched off, callers will no longer hear you.
Switch the microphone on/off during a call: Press .
Adjust the microphone sensitivity
Adjust the microphone sensitivity for the receiver or wired headset.
Set the acoustic profile to loud surroundings:
¤ Press and hold the button Use to set the sensitivity Save
The caller's number is sent.
Placing the handset in the charging cradle during a call:
¤ Press and hold down the handsfree key . . . Place the handset in the charging
cradle . . . hold for a further 2 seconds
Applies for the mode currently being used (handsfree, receiver or headset):
¤ Press . . . use to set the volume Save
The setting is automatically saved after around 3 seconds, even if Save is not pressed.
or: Briefly press the Profile key
¤ . . . Use to select Audio Settings OK OK Mic Sensitivity
OK Use to select Earpiece / Corded headset Use to set the sensitivity Save
To Next Page
Loading...
Need help?
General
