System-wide speaker call 73
System-wide speaker call
You can place a speaker call to an internal party on HiPath 4000 using the
loudspeaker on their telephone to establish a connection. You can also initiate
a speaker call from a consultation call.
To cancel a speaker call, replace the handset or - during an inquiry - resume
the call that was in progress.
From your handset, you can directly call any internal user whose telephone has
the speakerphone function or a loudspeaker.
A destination party is contacted via his or her internal phone number.
Speaker call
The handset is not in the charging cradle. Press and hold down the Talk key.
o Enter the code for "Speaker call" and
o the user's phone number.
A connection to that user's loudspeaker will immediately be established if:
• the station is not busy,
• the handset has not been lifted and
• speaker call protect is not activated.
The caller hears a confirmation tone when the connection has been established
and can start speaking.
The called party can accept the call by lifting the handset.
Note:
Please ensure for all functions that "Speaker call protect" is deactivated
on the relevant phones page 74.
If a speaker call is placed to a party and "Speaker call protect" is
activated, the speaker call will be ignored and a normal call will be
placed.
Privacy:
You can place a speaker call to a called subscriber but will not hear the
other party unless they have pressed the Talk key.
Note:
The number of possible speaker calls and normal calls is the same.
To Next Page
Loading...
Need help?
General
