Unitech PA500 User Manual

Chapter 1 Getting Started
5
Setting up the PA500
Perform the following set up tasks to begin using your device:
• Install the battery pack
• Charge your device
• Power on the PA500
Installing the Battery
WARNING! There is a risk of fire and burns if the battery pack is handled
improperly. DO NOT disassemble, crush, puncture, short external
contacts, or dispose the battery pack in fire or water. DO NOT attempt
to open or service the battery pack. Dispose of used batteries
according to the local recycling guidelines in your area.
A backup battery cell is embedded into your device to prevent data loss when the removable battery
pack is removed or completely discharged. The backup battery will keep the data and system settings up
to 1 hour if the main battery is removed.
NOTE: To enable the internal battery cell to provide backup power supply, charge your device
with the main battery pack for at least three and a half hours.
1. Position the battery pack, making sure the battery pack fits the shape of the battery
compartment.
2. Slide the battery pack into the battery bay. The battery pack locks to the chassis with an audible
click.

Unitech PA500 Specifications

System Memory

SDRAM	64 MB
Flash ROM	64 MB

Display

display resolution	240x320 QVGA
display type	Color Transflective TFT
touch screen	yes

Laser Bar Code Scanner

scan rate	104 scans/sec ± 12 scans/sec
scan angle default	47°±3°
scan angle reduced	35°±3°

Power

main battery voltage	3.7 V
main battery capacity	2200 mAh
rechargeable time	3.5 hours

Operating Environment

operating temperature	32°F to 122°F (0°C to 50°C)
storage temperature	-4°F to 140°F (-20°C to 60°C)
relative humidity	5% ~ 95% (non-condensing)

Weight and Dimensions

weight with battery and scan engine	Under 213 g
length	126 mm
height	23 mm