Unitech PA500 User Manual

Chapter 4 Wireless Communications
35
d. If there are networks already detected, tap and hold network name, then select Connect.
If none, tap Add New and follow all onscreen instructions.
e. Under the Network to access drop-down menu, select from the following network
connection options:
— All available
— Only access points
— Only computer-to-computer
f. When finished, tap OK.
To configure the wireless network connection settings, tap Start → Settings →
Connections tab → Network Cards. For more information on how to configure the
wireless network settings, tap Start → Help.
To connect to a wireless network:
1. Tap Start → Settings.
2. On the Connections tab, tap Network Cards.
3. Tap the Wireless tab.
4. On the command bar, tap Connect.
5. If a wireless network is connected, a “New Network Detected” callout appears.
6. Tap Connect.
For more information on how to connect to a wireless network, tap Start → Help.
Connecting to the Internet
After configuring your device’s wireless setting, you can now define the network settings you will be using
to access the Internet, connect to your office network and view intranet URLs.
Once you have established these network settings, use Internet Explorer Mobile to view Internet and
intranet sites.

Unitech PA500 Specifications

System Memory

SDRAM	64 MB
Flash ROM	64 MB

Display

display resolution	240x320 QVGA
display type	Color Transflective TFT
touch screen	yes

Laser Bar Code Scanner

scan rate	104 scans/sec ± 12 scans/sec
scan angle default	47°±3°
scan angle reduced	35°±3°

Power

main battery voltage	3.7 V
main battery capacity	2200 mAh
rechargeable time	3.5 hours

Operating Environment

operating temperature	32°F to 122°F (0°C to 50°C)
storage temperature	-4°F to 140°F (-20°C to 60°C)
relative humidity	5% ~ 95% (non-condensing)

Weight and Dimensions

weight with battery and scan engine	Under 213 g
length	126 mm
height	23 mm