Unitech PA500 User Manual

30
Copyright 2007 unitech Electronics Co., Ltd. All rights reserved. unitech is a registered trademark of unitech Electronics Co., Ltd.
Infrared Connection
Using infrared, you can enable short-range file exchange between your device and another IR-enabled
device.
To exchange files using IR connection:
1. Ensure that the IR function on both your PA500 and on other device(which you want to exchange files
with) are turned on.
2. Locate the item you want to send.
3. Align the IR port of your device with the IR port of the IR-enabled device, so that they are unobstructed
and within a close range.
4.
Tap and hold the item, then tap Beam [type of item] on the pop-up menu.
5. Tap the device that you want to send the file to.
To receive files via IR connection:
1. Align the IR port of your device with the IR port of the IR-enabled device, so that they are unobstructed
and within a close range.
2. Send the file from the other IR-enabled device.
3. On the Receiving Data callout, tap Yes.
Bluetooth Connection
Your device allows you to connect to any Bluetooth-enabled device in your personal area network
(PAN). Once connected, you can send and receive files to another Bluetooth-enabled device, locate and
use any of the services available on the Bluetooth-enabled device you are connected to.
To setup a Bluetooth connection:
1. Activate the Bluetooth function.
You have two options to activate your device’s Bluetooth connection using the Wireless
Manager or the Bluetooth option under the Settings → Connections preferences. Once
activated, Bluetooth connection is indicated as "On" in the Wireless Manager section of the Today
screen.
– To activate Bluetooth via the Wireless Manager, see “Using the Wireless Manager” on page
28.
– To activate Bluetooth using the Settings option:
a. Tap Start → Settings.
b. On the Connections tab, tap Bluetooth.

Unitech PA500 Specifications

System Memory

SDRAM	64 MB
Flash ROM	64 MB

Display

display resolution	240x320 QVGA
display type	Color Transflective TFT
touch screen	yes

Laser Bar Code Scanner

scan rate	104 scans/sec ± 12 scans/sec
scan angle default	47°±3°
scan angle reduced	35°±3°

Power

main battery voltage	3.7 V
main battery capacity	2200 mAh
rechargeable time	3.5 hours

Operating Environment

operating temperature	32°F to 122°F (0°C to 50°C)
storage temperature	-4°F to 140°F (-20°C to 60°C)
relative humidity	5% ~ 95% (non-condensing)

Weight and Dimensions

weight with battery and scan engine	Under 213 g
length	126 mm
height	23 mm