Unitech PA600 Getting Started

Chapter 3 Getting Connected
24
Copyright 2008 unitech Electronics Co., Ltd. All rights reserved. unitech is a registered trademark of unitech Electronics Co., Ltd.
Chapter 3
Getting Connected
Establishing Device-PC Connection
Installing Microsoft ActiveSync
Microsoft ActiveSync must be installed on the computer in order to exchange information
between the computer and the PA600. Microsoft ActiveSync is already installed on the
PA600. Use the PA600’s USB Charging Cable or the docking station to connect the
PA600 with a computer.
NOTE: If a previous version of Microsoft ActiveSync is installed on the computer,
uninstall it first, before installing the latest version of Microsoft ActiveSync.
The PA600 Phone Edition requires Mircosoft ActiveSync version 4.2 or
higher.
Install Microsoft ActiveSync on the computer through the following:
1. Close any open programs, including those that run during startup, and disable any
antivirus software.
2. Download the Microsoft ActiveSync software from the Microsoft ActiveSync Down-
load page at:
http://www.microsoft.com/windowsmobile/downloads/activesync42.mspx
3. Follow the onscreen instructions to install Microsoft ActivSync.

Unitech PA600 Specifications

System Memory

SDRAM memory	64 MB
Flash ROM	128 MB
Flash ROM with WWAN	320 MB

Display

display resolution	240x320 QVGA
display type	Color Transflective TFT
touch screen	Yes

Power

main battery	3.7V 1950mAh Li-Ion Battery Pack
backup battery	One Rechargeable Ni-MH Backup Battery
power source	Main Battery

Operating Environment

operating temperature	32ºF to 122ºF (0ºC to 50ºC)
storage temperature	-4ºF to 140ºF (-20ºC to 60ºC)
relative humidity	5% ~ 95% (non-condensing)

Weight and Dimensions

weight	290g with Battery & Scan Engine
length	149.5 mm
height	26.6 mm