Unitech PA600 Getting Started

Chapter 1 Getting Started
6
Copyright 2008 unitech Electronics Co., Ltd. All rights reserved. unitech is a registered trademark of unitech Electronics Co., Ltd.
Getting Started
Install and charge the battery, check the battery status, turn on the PA600, and cali-
brate the PA600’s screen through the following:
Installing the Battery
WARNING! If the Battery Pack is handled improperly there is risk of fire and/or
burns. Do not disassemble, crush, puncture, short external contacts,
or dispose the battery pack in fire or water. Do not attempt to open or
service the battery pack. Dispose of used batteries according to local
recycling guidelines.
A Backup Battery cell is embedded in the PA600 to prevent data loss when the remov-
able Battery Pack disconnects from the PA600. The Backup Battery will maintain data
and system settings for up to 6 hours.
NOTE: Initially charge the Main Battery for at least 16 hours to provide the bat-
tery with enough power.
1. Access the Battery Compartment by pushing the Battery Compartment cover
Latch in the direction as shown below:
Components of the Battery Compartment are highlighted below:
NOTE: Do not remove the Plastic Battery Tab, it is useful for removing the Bat-
tery.
Compartment Contacts
Plastic Battery Tab
Battery Hook

Unitech PA600 Specifications

System Memory

SDRAM memory	64 MB
Flash ROM	128 MB
Flash ROM with WWAN	320 MB

Display

display resolution	240x320 QVGA
display type	Color Transflective TFT
touch screen	Yes

Power

main battery	3.7V 1950mAh Li-Ion Battery Pack
backup battery	One Rechargeable Ni-MH Backup Battery
power source	Main Battery

Operating Environment

operating temperature	32ºF to 122ºF (0ºC to 50ºC)
storage temperature	-4ºF to 140ºF (-20ºC to 60ºC)
relative humidity	5% ~ 95% (non-condensing)

Weight and Dimensions

weight	290g with Battery & Scan Engine
length	149.5 mm
height	26.6 mm