Unitech UT-101 User Manual

@
sales@utplindia.in
+91 7046223333 , 9427301436
www.utplindia.in
www
UT-101
UNIVERSAL PROCESS INDICATOR CONTROLLER&
9
Continue Configuration Mode
WARNING
PERSONAL INJURY :
Configuration should be performed only by personnel who are technically competent to do
so. Local Regulations regarding electrical & safety must be observed.
FAILURE TO COMPLY WITH THESE INSTRUCTIONS COULD RESULT IN DEATH OR SERIOUS INJURY.
Range / Values
Parameter
nadd
0001
NODE ADDRESS [COMMUNICATION]
Device Address for Communication
Display
Increase the no. by key, decrease by key.
Range : Values between to0001 0127
Default Value : 0001
: Baud Rate 4800
4800
: Baud Rate 9600
9600
: Baud Rate 19200
19.2k
Change value by key, or by key.
baud
9600
BAUD RATE [COMMUNICATION]
Baud Rate for Communication
Values :
Default Value : 9600
NOTE : Applicable if Communication Output.
NOTE : Applicable if Communication Output.
:EvenParity
EvEn
:OddParity
Odd
: None Parity
none
Change value by key, or by key.
pr1t
none
PARITY [COMMUNICATION]
Parity check for Communication
Values :
Default Value : none
NOTE : Applicable if Communication Output.
: Linear Cycle
Lean
: Square root Cycle
SQrt
Change value by key, or by key.
Ctyp
Lean
CYCLE TYPE [LINEAR INPUT]
Value display for Analog input.
Values :
Default Value : none
NOTE : Applicable for Analog Linear input only.
oFfS
0038
OFFSET FOR INPUT [FACTORY SET VALUE]
Offset Parameter for corresponding Input
Value : Factory Set for every Input
Default Value : (As per Input)0038
NOTE : Factory set value, don’t change.
Increase value by key, decrease by key.
Ga1n
0007
GAIN FOR INPUT [FACTORY SET VALUE]
Gain Parameter for corresponding Input
Value : Factory Set for every Input
Default Value : (As per Input)0007
NOTE : Factory set value, don’t change.
Increase value by key, decrease by key.
: Selected
YES
:Not
no
DEAD
no
DEAD BAND
Operate Relay-1 on two setpoints
Values :
Default Value : no
If set as , Only Relay-1 get operated in thisYES
parameter, relay get active on set point 1[ ]SP1
value and deactivate in set point 2[ ] value.SP2
Used for Level Control & Fan Operation.
Increase by key, Decrease by key.

Unitech UT-101 Specifications

General

Brand	Unitech
Model	UT-101
Category	Controller
Language	English