Page | 9
1. Quick Set-up
Set-up one component at a time, and you’ll
move quickly through your system.
Step 1: Turn on the component you want to
activate. (Other components can be on or
off, it doesn’t matter.)
STEP 2: Point your new WR7 universal
remote toward the component and press the
appropriately labeled Component button (TV
for TV, DVD for DVD, etc.) While holding
this button down,press the numeric assigned to
your brand in the Quick Set-up Code Table(See
Page 2) and release both Component
button and the number key to save the code.
The component light will blink three times to
confirm that the code has been stored.
STEP 3:
Point the remote control at the component.
STEP 4: Press the power button. If it turns
off, it is programmed for your component. If
it does not turn off, use the Pre-Programmed
3-Digit code Method or Auto-Search
Method.
Check your work Press the POWER [ON]
button to turn the component back on.
Next, test the VOLUME and CHANNEL
buttons (or PLAY and STOP buttons for VCR
and DVD) to make sure they all work. Repeat
steps one through four until all your
components are set up properly.
COMPONENT
BUTTONS
NUMBER
PAD
To Next Page
Loading...
Need help?
General
