Universal Remote Control WR7 User Manual

Page | 14
Set-up using the
Learning Method
STEP 1: Line up the WR7 to the remote control
you want to “learn” from, head-to-head as shown
below. Start with the two remotes' infrared (IR)
window touching, or nearly touch.
STEP 2: On the WR7, press the Component
button that you want to set up and the ENTER [ENT]
button at the same time. Hold down both buttons
for two seconds until the Component button light
turns on. This signals that you are in set up mode.
STEP 3: Press any button on the WR7 that you
want to teach a command to. For example, if you
want to teach the [MUTE] button on the WR7 the
TV Mute command from the other remote, first
press the [MUTE] button on the WR7. The TV
Component button light will blink once indicating
that the WR7 is ready to learn the command.
STEP 4: Press and hold the appropriate button on
the other remote until the component button light
on the WR7 blinks twice. This indicates the WR7
has learned the command from your other remote.
Didn’t work? Tap and release the button on your
old remote instead of pressing and holding the
button down See other tips on page 16.
ENTER
BUTTON
COMPONENT
BUTTONS

Universal Remote Control WR7 Specifications

General

Brand	Universal Remote Control
Model	WR7
Category	Universal Remote
Language	English