Universal Remote Control WR7 User Manual

Page | 27
Channel Control Punch Through
This punch through enables you to set up the
WR7 remote so that VCR or DVD Transport
Controls (PLAY, STOP, FF, REW, PAUSE, SKIP
and RECORD) will also operate in other
component modes on the remote control.
STEP 1: Press and hold the component
button you want to add Transport Control to,
such as [CABLE/SAT] or [TV], and the SELECT
[SEL] button at the same time for two seconds
until the Component LED light turns on.
STEP 2: Press the [PLAY] button.
The component LED light will blink once.
Note: If you do not press a button within 30
seconds, the component light will turn off.
The remote will exit the set up mode, and you
will have to start over with step one.
STEP 3: Press either the [DVD] or [VCR]
button that you want to use as the source of
Transport Control. The component light will
blink three times to confirm it is saved.
Transport controls
COMPONENT
BUTTONS
SELECT
PLAY

Universal Remote Control WR7 Specifications

General

Brand	Universal Remote Control
Model	WR7
Category	Universal Remote
Language	English