Page | 13
Continue pressing the up or down button, in
approximately one second intervals, until the
component turns off. (DO NOT alternate
the up and down button. You want to move
in only one direction.)
STEP 4: Once the component has turned off,
check your work. Press the POWER [ON]
button on the WR7 remote to turn the component
back on.
Next, test the VOLUME and CHANNEL
buttons (or PLAY and STOP buttons for VCR
and DVD) to make sure they all work. If the
buttons do not work properly, you need to
find a new code. Continue pressing the UP
(or DOWN) arrow button until you find a
new code that turns off the component and
makes the VOLUME or PLAY buttons respond
correctly.
STEP 5: Save your work. Once you have
found the right code, you must save it. Press
the component button you just activated one
more time to save the code number. The
component light will blink three times to
confirm that the code was successfully stored.
Note: It may take up to five minutes to work
your way through the entire pre-programmed
table. If you cannot find the right code after 5
minutes of trying the Auto-Search Method, try
the Learning Method (page 14)
To Next Page
Loading...
Need help?
General
