Operation Panel
4-134
2 Press [OK]. The NW User Property menu screen appears.
The options available in NW User Property are as follows:
• Off/On (Switching network user property acquisition On/Off)...4-
134
• Authenticat Type (Authenticat type setting)...4-134
Off/On (Switching network user property acquisition On/Off)
Set the NW User Property to On/Off.
1 In the NW User Property menu, press or to select Off/On.
2 Press [OK]. The Off/On screen appears.
3 Press or to select On or Off.
4 Press [OK]. The NW User Property menu reappears.
Authenticat Type (Authenticat type setting)
Set the authentication method.
1 In the NW User Property menu, press or to select
Authenticat Type.
2 Press [OK]. The Authenticat Type screen appears.
3 Press or to select Simple or SASL.
4 Press [OK]. The NW User Property menu reappears.
PIN Login
This sets whether or not to login using PIN. When set to On, you can login by entering PIN on the login screen.
1 In the User Login Set. menu, press or to select PIN Login.
2 Press [OK]. The PIN Login screen appears.
3 Press or to select On or Off.
4 Press [OK]. The User Login Set. menu reappears.
NW User Property:
Off/On
Exit
Authenticat Type
01
02
Note Authenticat Type is only displayed when
Kerberos has been set as the Server Type (Server type
selection) on page 4-132.
Authenticat Type:
Simple
01
SASL
02
*
Note This setting is only displayed when Netwk Authentic. has been set as the Login Type (Enabling of User
Login Administration) on page 4-131 and This setting is only displayed when Ext. has been set as the Server Type
(Server type selection) on page 4-132.
To Next Page
Loading...
Need help?
General
