1
2
Fig. 2: Rear of the indicating/adjustment module
1 Integrated seal ring
2 Gold plated contact paths
3.2 Principle of operation
The indicating and adjustment module is used for measured
value indication, adjustment, and diagnostics for the following
VEGA plics
®
sensors:
l VEGAPULS series 60
l VEGAFLEX series 60
l VEGASON series 60
l VEGABAR series 50 and 60
l VEGACAL series 60
The indicating and adjustment module is integrated in the
respective sensor housing or in the external indicating and
adjustment unit VEGADIS 61. After mounting, the sensor and
the indicating and adjustment module are splash-proof also
without housing cover.
The operation of two indicating and adjustment modules in
parallel in the sensor and in VEGADIS 61 is not supported.
Power is supplied directly by the respective sensor or by
VEGADIS 61. An additional connection is not necessary.
The backlight is also powered by the sensor or via VEGADIS
61. Prerequisite for this is a supply voltage at a certain level.
The exact voltage specifications can be found in the operating
instructions manual of the respective sensor.
Area of application
Supply
8 Indicating and adjustment module PLICSCOM
Product description
27835-EN-070123
To Next Page
Loading...
Need help?
General
