NOTE: this operation can be carried out while
the machine is turned on.
All models are fitted with a hot water
mixer, which serves to adjust the temperature
of the water leaving the wand and to optimise
system performance.
To set the hot water economy device, use a
screwdriver on the screw in the top part of the
machine, as shown in the figure.
7XUQLW&/2&.:,6($17,&/2&.:,6(WR
REDUCE / INCREASE the temperature of
the hot water;
Fig. 15
5.1 HOT WATER
ECONOMISER
ADJUSTMENT
5. ADJUSTMENTS TO BE MADE BY A QUALIFIED TECHNICIAN ONLY
5.2 REPLACING THE
CLOCK BATTERY
The electronic control unit has a lithium battery
to power the clock; the battery has an autono-
my of about three years, after which it will need
to be replaced.
In case of an extended period of machine stop-
page, the clock can be stopped:
with the machine off the display will read:
KROGWKH212))NH\GRZQ for 5 sec.
to release the clock.
Replacement of the lithium battery must be
carried out EXCLUSIVELY by Qualified
Technician.
Victoria Arduino cannot be held liable for
any damage to people or things due to non
observance of the safety prescriptions
described in this booklet.
WARNING
OFF
CLOCK DISABLED
To Next Page
Loading...
Need help?
General
