Before starting to use the appliance, the opera-
tor must be sure to have read and understood
the safety prescriptions contained in this book-
let.
When commissioning the machine for the first
time or after carrying maintenance switch ON
the machine using the main switch positioned
lower down and on the right and proceed as
follows:
,I WKH PHVVDJH ³2)) ± &/2&.
DISENABLED” appears on the display pro-
ceed as follows in step three.
2) If the display reads “OFF“ press the ON/
OFF
NH\XQWLOLWUHDGV³2))±&/2&.
DISABLED“ and then proceed as described
in step 3.
3) Switch on the machine using the ON/OFF
key and automatically after the
machine has switched on, some water will
be poured from the groups for about 45
seconds to make sure that the coffee boiler
tanks have been properly filled.
This cycle cannot and must not be inter-
rupted.
If this cycle is interrupted due to a power
outage or if the machine is accidentally
switched off from the main switch, the next
time the machine is switched on, the cycle
will be started again for approximately 45
seconds more.
6.2 SWITCHING THE
MACHINE ON/OFF
SWITCH ON: plug the machine into the
power socket and press the
switch “A” so it is in position “I”;
the machine will switch on.
7KHOLWGLVSOD\ZLOOVKRZWKHILUPZDUHYHUVLRQ
for about 1 second:
For electronic card maintenance, turn the
machine off by means of the external main
switch or disconnect the plug.
WARNING
MANUAL SWITCHING ON/OFF
Automatic On/Off NOT PROGRAMMED
NOTE: make sure that the general switch is
always on the position “I”.
6. USE
SWITCH ON: press the ON/OFF button
for about 2 seconds until the
light switches on and the buzz-
er makes a beep sound.
The control unit will start up an
auto diagnosis cycle to check
the functions, all the selection
keys will light up.
6.1 COMMISSIONING
PROCEDURE OR
AFTER BOILER
MAINTENANCE
To Next Page
Loading...
Need help?
General
