39
In case of emergency
Erasing fault codes
Any fault codes in the diagnostic function are
automatically erased every time the starter key is tur-
ned to the stop position (S).
NOTE! Stop the engine and check that the ignition
key(s) is(are) in position 0 in all control positions.
When system voltage is switched on again, the
diagnostic function checks to see whether there are
any faults in the EVC system. If this is the case, new
fault codes are set.
This means that:
1. Fault codes for malfunctions which have been
attended to or have disappeared are automatically
erased.
2. Fault codes for malfunctions which have not been
attended to must be acknowledged every time the
system voltage is switched on.
If the diagnostic button is pressed after all stored fault
codes have been erased, code 1.1 (“No fault”) will be
flashed out.
To Next Page
Loading...
Need help?
General
