220 Cab Interior and Sleeper
Sleeper Compar tment Sink
A built-in sink is available as optional
equipment for the VN-770 sleeper model. It
is located on the left side, in the cabinet be-
hind the driver.
The sink is mounted in the drawer space.
To pull out, grasp the drawer lip and re-
lease the latch. Pull out until the faucet can
be raised without hitting the cabinet.
CAUTION
Never run the pump without water in the
freshwater tank. The pump may be dam-
aged if run dry.
W8002162
To operate the water pump there is a com-
bined valve and switch in the knob (1) on
the base. Turn on the 12V switch on the
sleeper switch panel to the left of the tower
cabinet, then turn the knob slightly to start
the pump. Turn the knob further to increase
water flow. When the knob is turned fully
back to rest position, the pump will stop.
CAUTION
Make sure the pump is turned off before
pushing the drawer in. If the pump con-
tinues to deliver water, overflowing
water can flood the cab floor.
In the bottom of the sink there is a spring
loaded drain plug that is sealed by pressing
down and twisting clockwise. To release
for letting water drain off, turn counter-
clockwise and the spring will lift the plug
and open the drain.
W8002161
To Next Page
Loading...
Need help?
General
