Instruments and Controls 87
High Beam Telltale
Any time the high beams are activated, by
the high/low beam switch or the high beam
flash switch, the telltale lights up blue. For
information on switching high/low beam,
see page 97.
W3001303
Safety Belt Telltale
The telltale lights up red each time the ig-
nition is turned on to remind the driver to
fasten the safety belt. It stays lit for 10 sec-
onds and then goes out automatically.
Before adjusting the safety belt, make sure
the vehicle is stationary and that the seat
has been adjusted as required. Do not at-
tempt to adjust the safety belt or seat while
the vehicle is in motion. For proper use of
the safety belt, see page 52.
W3000625
Parking Brake Telltale
The telltale lights up red when the parking
brake valve knob is pulled out. The day-
time running light (DRL) function is also
dependent on the parking brake application.
Any time the parking brake telltale is on,
the DRL is deactivated.
Never exit your vehicle unless the park-
ing brake is set. Failure to do so can
result in unexpected vehicle movement
and cause personal injury or death.
For proper use of the parking brake, see
page 278.
W3000627
To Next Page
Loading...
Need help?
General
