VTech BM2600 User Manual

8
9
Getting started
Parent unit battery charging
The parent unit turns on after you have installed the parent
unit battery or connected the parent unit to AC power (see
pages 5 to 8). The battery icon indicates the battery status
(see the table below). The parent unit battery is fully charged
after 12 hours of continuous charging.
When the parent unit is operating in battery mode and the
battery is low, you need to charge the parent unit without
interruption for at least 30 minutes to give the parent unit
enough charge to use for a short time. When operating in low
battery condition, the parent unit displays . The light
on the parent unit flashes and the parent unit plays short
beeps to alert you.
The following table summarizes the battery charge indicators
and actions to take.
Battery
indicators
Battery status Action
The battery icon is
off and displays.
No battery is installed
but operates using AC
power, or the battery has
been installed incorrectly.
Install the parent
unit battery. Charge
without interruption
(at least 30 minutes).
The screen
displays . The
light flashes.
The battery has very little
charge and may be used
for only a short time.
Charge without
interruption (about
30 minutes).
The battery icon
becomes solid .
The battery is fully
charged.
To keep the battery
charged, connect it
to AC power when
not in use.
When you charge the battery pack initially or it is not used for a
long period of time, charge it for 12 hours continuously. It takes
longer to charge the battery when the parent unit is turned on.
To shorten the charging time, turn the parent unit off.

VTech BM2600 Specifications

General

Brand	VTech
Model	BM2600
Category	Monitor
Language	English