Operation
Driving with water sprinkling system
BA RD18 en 01
93
3.18 Driving with water sprinkling system
After each engine start water sprinkling system is deactivated.
The water sprinkling system wets the drums/tyres and the edge pressure
and cutting device with water. The wetting prevents that bitumen sticks on
roller drums/tyres when laying blacktops. This is the way to make a neat
and even covering.
An electric water pump supplies the water sprinkling system with water.
The built-in automatic sprinkling unit adjusts the water consumption to
match the conditions of use optimally. A multilevel automatic interval
system determines the minimum use of water for optimum moisturing,
using a combination of spray quantity and pump pause time. The water
pump can also be switched manually to continuous operation at any time.
NOTE
The sprinkling control is switched off at a road speed of less
than 0.5 km/h (0.3 mph).
Continuous operation is still possible in this case.
Sprinkling the roller drum/tyres
Requirement: Diesel engine is running, water sprinkling system is
activated.
When the driving speed exceeds 0.5 km/h (0.3 mph) the sprinkling is
switched on.
When the machine is at a standstill, the sprinkling is switched off.
Switching the water-sprinkling system on and off
Activating the water-sprinkling system
Prerequisite: Electrical system is ON
Press the switch [1].
a
The illuminated dots [3] show the current sprinkling stage.
a
The indicator LED [2] is on when the sprinkling system is switched on
via the automatic interval system.
Deactivating water sprinkling system
Press the switch [1] again.
a
Water sprinkling system is deactivated.
To Next Page
Loading...
Need help?
General
