Wacker Neuson WM 80 User Manual

Disassembly and Assembly WM 80 Repair
108 wc_tx000523gb.fm
10.7 Removing Engine From BS Model Rammers
(standard choke models)
See Graphic:wc_gr002935
Removal:
10.7.1 Stop the machine and allow it to cool.
10.7.2 Remove the carburetor. See section Removing Carburetor.
10.7.3 Remove the muffler guard (a) (if equipped) and the muffler (b).
10.7.4 Disconnect the connector (c) from the stop switch.
10.7.5 Remove the three socket head cap screws (d) that hold the engine to
the crankcase.
10.7.6 Tilt the engine down and away to remove it from the crankcase.
NOTICE: The rammer tips easily when the engine is removed.
DO NOT run the engine while it is off the machine unless the clutch (e)
has been removed. Running the engine with the clutch attached to the
crankshaft will cause the clutch shoes to separate and fly off.
Installation:
10.7.7 Position the engine onto the machine. Using Loctite 234 or equivalent
on the three screws (d), secure the engine to the machine. Torque the
screws to 27 Nm (20 ft.lbs.).
10.7.8 Reconnect the stop switch.
10.7.9 Install the muffler (b) and muffler guard (a).
10.7.10 Install the carburetor. See section Removing Carburetor.
WARNING

Wacker Neuson WM 80 Specifications

General

Brand	Wacker Neuson
Model	WM 80
Category	Engine
Language	English