DVS/GSE GSE DVS Field Service Manual
09030-78B 25 of 49
Webasto Charging Systems, Inc.
do not describe the operations in detail. When removing components, take time to note the
locations of hardware and electrical connections so they can be reinstalled in the proper locations.
3.1.4.1 Door Assembly (P/N 07308)
The door assembly includes the permanently attached membrane switch panel, a display module,
and the control board
1. Disconnect all electrical connections coming from the power station and free wires from wire
guides on door assembly.
2. Open door 90° and lift door assembly approximately one inch using even upward force along
hinge axis. This will free the door from the two hinge pins on the power station.
3. Reverse these steps to install door assembly.
To Next Page
Loading...
Need help?
General
