Instructions for Assembly
Item number 116523-0000
We reserve the right to make technical
changes
Version 4 01.04.2014 Page 14/49
Opal Design II / Opal Design II LED
5 Assembly
5.1 Safety notes
Beware of missing or incorrect brackets as well as incorrect assessment of installation
surface.
Check before beginning the assembly work
that the mounting brackets supplied are of the same type and of the same quantity as
ordered,
that the information provided in the order about the installation surface tallies with the actual
installation surface on site.
If any deviations are found, which pose a safety risk, do not carry out the assembly
work.
A space of at least 30 mm from the side of the wall is needed in order to fit the cover
caps.
The brackets must be located where the arm brackets are located (marking points on the
rear of the awning)!
A maximum deviation from the centre of the arm bracket to the centre of the bracket ±100
mm is possible!
DANGER
To Next Page
Loading...
Need help?
General
