Instructions for Assembly
Item number 116523-0000
We reserve the right to make technical
changes
Version 4 01.04.2014 Page 25/49
Opal Design II / Opal Design II LED
5.4.3 Fit the rafter bracket with mounting plate
We recommend using the mounting plate to fit the rafter brackets as it provides for a
better shear force transfer.
1. Fit the rafter bracket
1. Screw the rafter bracket to the
mounting plate taking the roof pitch
into account.
2. Align the mounting plate to the rafter
and mark where the two holes
should be drilled. Make sure the
required minimum distance from the
edge of the rafter is kept. Drill the
two ≤ Ø13 mm through holes.
3. Push in the C2 plate dowels
together with the screws and the
shims. As you do this, ensure that
you do not bend the teeth on the
plate dowels.
4. Fit the rafter bracket with mounting
plate to the rafter.
2. Mount the wall bracket
1. Mount the wall bracket to the rafter
bracket
2. Align the distance according to width
of awning
3. Attach the awning
4. Attach clamp profiles to the wall
bracket
To Next Page
Loading...
Need help?
General
