Instructions for Assembly
Item number 116523-0000
We reserve the right to make technical
changes
Version 4 01.04.2014 Page 40/49
Opal Design II / Opal Design II LED
9 Electrical connection
9.1 Safety notes
Electrical hazards
Electrical hazards occur when the electrical connections are not performed properly.
The awning may only be connected to an electricity supply if the specifications
provided on the tag attached to the awning and/or the specifications provided in the
supplied assembly instructions tally with the power source. At the very least, the tag
and/or specifications must specify the voltage, frequency and output values.
A permanent electrical connection may only be made to power grids fitted with an all-
pole disconnector with a minimum 3 mm wide contact gap.
The installation instructions accompanying the supplied electrical components must
be observed.
9.2 Setting the end positions
Damage to the product
Incorrectly set end positions can result in the product being damaged.
Do not exceed the maximum permissible awning length.
The middle joint must be only opened far enough so that the high-tech belt is no
longer visible.
The end positions for the drive are pre-set at the factory. Should these need to be
adjusted, however, always follow the instructions provided in the technical documents
that accompany the electric drive.
Check that the drive is switched off
1. Once the awning has been installed, check that the drive has been switched off
correctly. The cassette must close when the awning is retracted.
2. Re-set if necessary.
If a larger angle of pitch is set, it may be necessary to re-program the end positions for
the drive.
DANGER
CAUTION
To Next Page
Loading...
Need help?
General
