5.4.5 Replacing the rinse aid canister
For your safety when using the combi oven
Before starting work, it is essential that you familiarize yourself with the rules and hazard warnings specified in the chapter
'For your safety on page
19' and in this instruction manual, and follow the instructions given there.
Materials required
■
One empty canister (10 litres) for the ConvoCare rinse aid
■
Enough soft water (approx. 10 litres); (for specification see the 'W
ater quality' section of the 'Technical data' in the Instal-
lation manual)
■
ConvoCare K concentrate (0.33 l)
Mix up the ConvoCare rinse aid in the canister
To avoid excessive foaming, follow the procedure below when mixing the ConvoCare K concentrate with soft water to pro-
duce the rinse aid:
1.
Open the empty canister (1).
2.
Fill the canister with soft water (2) until it reaches just below the 10 litre
mark (4).
3.
Risk of irritation to skin, eyes and respiratory system
■
Do not let the rinse aid come into contact with skin, eyes or mucous
membranes.
■
Do not inhale vapours from the rinse aid.
■
W
ear personal protective equipment.
Then pour 0.33 l of the ConvoCare K concentrate (3) carefully into the
canister (1).
4.
Check the fluid level in the canister:
■
If the level is below the 10 litre mark (4), carefully add the extra
amount of soft water (2) required.
■
If the level is above the 10 litre mark (4), the rinse aid is a little less
concentrated than specified. You can still use the rinse aid at the
lower concentration.
5.
Replace the cap on the canister and tip it up to mix the liquids together
thoroughly.
5 Cleaning procedures
User manual 97
To Next Page
Loading...
Need help?
General