Installation
2–2 975-0082-01-01
Preparing an Installation
Before you install the Auto Gen Start, you must consider how and where
the unit will be mounted, and plan the connection routes between the
Auto Gen Start, the generator, thermostats and the control panel.
Tools and materials required
Before beginning an installation, you will need the following tools and
materials:
❐ Mounting template (supplied)
❐ Wiring harness (Xantrex part number 809-0917, supplied)
❐ Four #6 screws, 1 1/4 inch (supplied)
❐ #16 or #18 AWG wire (see “Wire size and length” on page 2–7)
❐ Xantrex network cables or equivalent
❐ Network terminators (if required)
❐ Phillips screwdriver
❐ Wire cutters
❐ Wire strippers
To Next Page
Loading...
Need help?
General