Installation
2–4 975-0082-01-01
Because the Auto Gen Start will be part of a Xanbus system, you must
consider how to route two types of connections:
• connections to the generator, thermostats, and other external devices
and switches, using the 20-contact connector and wiring harness.
• connections to other Xanbus-enabled devices, using network cables.
For information on designing and installing the network, see the Xanbus
System Installation Guide.
Installing the Auto Gen Start
After selecting your tools and choosing the best location and connection
routes for your installation, you are now ready to mount the Auto Gen
Start and connect it to the generator, thermostats and System Control
Panel.
Figure 2-1
Auto Gen Start external connections
Wiring harness (connection
to generator, thermostats,
and external switches)
Network cables to other
Xanbus-enabled devices
20-contact
connector
Network ports
To Next Page
Loading...
Need help?
General