Operation
4–6 975-0082-01-01
Changing System Modes
The system modes described in this section affect the behavior of the
Auto Gen Start and every Xanbus-enabled device in the system. You will
have to change the system mode when setting a Generator Type,
travelling, putting your vehicle in storage, or when installing a new
Xanbus-enabled device.
The system modes you can select are:
• Operating
• Power Save
•Safe
• Hibernate
You can change system modes using the System Settings menu on the
System Control Panel. The System Settings menu appears as the last item
on the Select Device menu.
To view the System Settings menu:
1. On the Select Device menu, use the down arrow button to highlight
System (see Figure 4-1).
2. Press Enter.
The System Settings menu appears.
To change the System mode:
1. On the System Settings menu, with Desired Mode highlighted, press
Enter.
2. Use the up or down arrow button to selected the desired system mode.
3. Press Enter.
Figure 4-2
Changing the system mode
To Next Page
Loading...
Need help?
General