10
© 2001 Xantrex Technology Inc.
P/N 973-0012-01-02 Rev. A 05/01
Mounting Circuit Board to an Existing Shunt
Model TM500A - NS is supplied without a shunt and is intended to be
wired to an existing shunt. The kit includes two brass 8-32 x 5/8 inch
machine screws, two lock-washers and two metal standoffs.
NOTE: The shunt must be of the proper type (50 mV/500 amps) and
have the necessary threaded screw holes to accommodate the shunt
board.
• Remove the existing two machine screws (if installed) and hardware
from the side of the shunt.
• Install the shunt circuit board and supplied hardware exactly as shown
in Figure 2-8.
NOTE: Use only the hardware supplied in the kit.
Figure 2-8
Shunt Circuit Board and Hardware
Brass Screw
Metal Standoff
Brass Lock
Washer
Spade Lug
(for extended length installations)
2.0 INSTALLATION
To Next Page
Loading...
Need help?
General
