Xerox Phaser 3500 Service Manual

Phaser® 3500 Laser Printer Service Manual
vii
Servicing Electrical Components
Before starting any service procedure, switch off the printer power and unplug the power cord
from the wall outlet. If you must service the printer with power applied, be aware of the
potential for electrical shock.
Warning: Turning the power off by using the On/Off switch does not completely de-energize
the printer. You must also disconnect the printer power cord from the AC outlet. Position the
power cord so that it is easily accessible during servicing.
Warning: Do not touch any electrical component unless you are instructed to do so by a
service procedure.Servicing Mechanical Components
Caution: When servicing mechanical components within the printer, manually rotate drive
assemblies, rollers, and gears.
Warning: Do not try to manually rotate or manually stop the drive assemblies while any
printer motor is running.
Warning: This printer uses heat to fuse the toner image to media. The Fuser Assembly is
VERY HOT. Turn the printer power off and wait at least 5 minutes for the Fuser to cool before
you attempt to service the Fuser Assembly or adjacent components.
Regulatory Specifications
Regulatory Specifications for this printer can be found in the User Guide and on the Xerox
Website.

Xerox Phaser 3500 Specifications

General

Brand	Xerox
Model	Phaser 3500
Category	Printer
Language	English