Using the Manual Feed Mode
Phaser® 3500 Laser Printer
18
3. Slide the extender toward you until it locks into place.
4. Adjust the paper guides to match the size of the paper, transparency, or other specialty
media.
5. When prompted at the control panel, insert paper, transparency, or other specialty media
into the tray. Place the side to be printed face up with the top of the page entering the
printer first.
6. If necessary, press the guides inward to match the size of the paper.
Tray 1 (MPT) detects the paper and prints the page.
Selecting the Bypass Tray 1 (MPT) Mode
The Bypass Tray 1 (MPT) mode setting can be set from the control panel. There are two
options:
When the bypass mode is enabled (On), the printer prints the job on the paper loaded in
Tray 1 (MPT) even if it does not match the paper type and size selected for the print job. To
use a tray other than Tray 1 (MPT), you must select Force printing from a specific tray in
your printer driver.
When the bypass mode is disabled (Off), the printer prints from the tray containing the
requested paper type and size for the print job.
To Next Page
Loading...
Need help?
General