Printing
Phaser 7500 Color Printer
User Guide
69
Printing on Special Media
This section includes:
• Printing on Transparencies on page 69
• Printing on Envelopes on page 70
• Printing on Labels on page 70
• Printing on Glossy Paper on page 71
• Using Custom Paper Types on page 72
• Using Custom Size Paper on page 73
Printing on Transparencies
Transparencies can be printed from Tray 1 (MPT) and Tray 2. They should be printed on one side only.
For best results, use only recommended Xerox transparencies.
To order paper, transparencies, or other specialty media, contact your local reseller or go to
www.xerox.com/office/7500supplies.
Caution: Damage caused by using unsupported paper, transparencies, or other specialty media is
not covered by the Xerox warranty, service agreement, or Total Satisfaction Guarantee. The Total
Satisfaction Guarantee is available in the United States and Canada. Coverage may vary outside
these areas; please contact your local representative for details.
See also:
www.xerox.com/paper Recommended Media List (United States)
www.xerox.com/europaper Recommended Media List (Europe)
Guidelines
• Remove all paper before loading transparencies in the tray.
• Do not load more than 50 transparencies in Tray 1 (MPT). Do not load more than 100
transparencies in Tray 2. Overloading the tray may cause the printer to jam.
• Handle transparencies by the edges using both hands to avoid fingerprints and creases, which can
cause poor print quality.
• After loading the transparencies in the tray, use the control panel to change the paper type to
Xerox Transparency.
To Next Page
Loading...
Need help?
General