Xerox Phaser 7760 User Guide

Overview of Network Setup and Configuration
Phaser® 7760 Color Laser Printer
2-2
Overview of Network Setup and Configuration
To set up and configure the network:
1. Turn on the printer and the computer.
2. Connect the printer to the network using the recommended hardware and cables.
3. Print the Configuration page and keep if for referencing network settings.
4. Configure the printer’s network address, which is required to identify the printer on the
network.
■ Windows operating systems: Run the Installer on the Software and Documentation
CD-ROM to automatically set the printer’s IP address if the printer is connected to an
established TCP/IP network. You can also manually set the printer’s IP address on the
control panel.
■ Macintosh systems: Manually set the printer’s network address (for TCP/IP) on the
control panel.
5. Install the driver software on the computer from the Software and Documentation
CD-ROM. For information on driver installation, see the section in this chapter for the
specific operating system you are using.
Note: If the Software and Documentation CD-ROM is not available, you can download the
latest driver from www.xerox.com/office/drivers
.
For more detailed networking information, see the Advanced Features Guide at
www.xerox.com/office/7760support.
Downloaded From ManualsPrinter.com Manuals

Xerox Phaser 7760 Specifications

General

Brand	Xerox
Model	Phaser 7760
Category	Printer
Language	English