Xerox Printer User Manual

USING HFDL COMMANDS
• COMMENT
• END.
You must place coordinates within the boundaries of the physical
page. If coordinates stay within the physical page, but extend
beyond the virtual page, HFDL issues a warning message. The
size of the lines table, currently set at 1,500, determines the
maximum number of lines and boxes. Text must fit on the
physical page. You can enter up to 4,096 characters in a text
block.
LINE command
Use the LINE command to specify one or more lines in the same
direction on your form.
Figure 3–11 shows the LINE command syntax.
Figure 3–11. LINE command syntax
AT
LINE
DRAW units
C
o
n
HORIZONTAL
FROM units
C
e
C
s
TO
;
USINGUSING SOLID
HAIRLINE
INK
units IN
BROKEN
DOTTED
0
1
2
VERTICAL
units
n
AND
units
units
AT
EVERY
REPEAT HORIZONTALLY
VERTICALLY
C
i
C
a
,
LINES
Parameters C
o
allows you to specify a line origin location on the form grid,
measured from the origin AT location, the point at which the line
begins. If the line is horizontal, C
o
represents the origin in the
vertical direction (
y –axis coordinate); if the line is vertical, C
o
HOST FORMS DESCRIPTION LANGUAGE 3.2 FOR IBM MVS CREATING FORMS 3–13

Xerox Printer Specifications

General

Brand	Xerox
Model	Printer
Category	Printer
Language	English