17
Set IPSec
Note: Before setting [Digital Signature] for [IKE Authentication Method], you will have to import an IPSec
certificate according to same procedure as "Configuring Machine Certificates" (3.4).
1. Click [+] on the left of the [Security] folder on the [Properties] screen.
2. Click [IPSec].
3. Enable the [Protocol] by placing a check mark in the [Enabled] box.
Choose [Pre-Shared Key] setting (4 - 5) or [Digital Signature] setting (6 -11).
4. Select [Pre-Shared Key] for IKE Authentication Method. This is to use the Shared Secret (between this device
and remote computers also possessing the secret).
5. Enter a Pre-Shared Key in the [Shared Key] and [Verify Shared Key] box.
Please set the IPSec address successively.
6. Click [Certificate Management] in the [Security] folder.
7. Select [IPSec] for Certificate Purpose.
8. Click the [Display the list] button, and check a desirable Certificate.
9. Click the [Certificate Details] button.
10. Click the [Use this certificate] button.
11. On the [IPSec] screen, Select [Digital Signature] for IKE Authentication Method.
Please set the IPSec address successively.
Set IPSec Address
12. Enter the IP Address in the [Specify Destination IPv4 Address] box on the [IPSec] screen.
13. Enter the IP Address in the [Specify Destination Ipv6 Address] box.
14. Select [Enabled] or [Disabled] from the [Communicate with Non-IPSec Device] dropdown list.
15. Click the [Apply] button.
16. Click the [Reboot Machine] button.
To Next Page
Loading...
Need help?
General
